What is the minimum size for a roof ridge board?
A ridge board must be at least 1 inch nominal thickness and no less in depth than the cut end of the rafter (IRC R802.3).
Where rafters meet at a ridge, they must be placed directly opposite each other and nailed to a ridge board. The ridge board supports and aligns the rafter ends in a conventionally framed roof.
The IRC requires the ridge board to be at least 1 inch nominal in thickness and not less in depth than the cut (plumb) end of the rafter, so the full bearing of the rafter is supported.
A non-structural ridge board is different from a structural ridge beam; a ridge beam is sized by engineering when it carries roof loads instead of relying on ties.
Verified against
Related answers
- When are rafter ties required, and how far apart can they be? — IRC §R802.3.1
- How much attic ventilation do I need? — IRC §R806.2
- What size does an attic access opening need to be? — IRC §R807.1
- How much attic/ceiling insulation does the energy code require by climate zone? — IRC §N1102.1.1
- What is the minimum roof slope for asphalt shingles? — IRC §R905.2.2
- Where is an ice barrier (ice and water shield) required on a roof? — IRC §R905.1.2
Have a question about your own project?
Adopted edition and local amendments vary by city and county. Get answers with code references to verify against your local code.
Ask Donnie →General information based on the International Residential Code (a model code). This is AI assistance to verify — not legal advice. Confirm the adopted edition and any local amendments with your local building department (AHJ) and a licensed professional before you build.