← Blog

Takeoff

How to do a wall framing takeoff

By Ask Donnie · · 7 min read

A framing takeoff turns wall lengths into studs, plates, headers and sheathing. Simple stud math gets you close. The extras at corners, intersections and openings are what turn a close count into a real lumber list.

1. Measure every wall run

Take the linear feet of each exterior and interior wall from the plan, and note the wall height and stud size for each. Keep exterior walls, interior walls and any taller walls on separate lines.

2. Common studs

Studs = wall length in inches ÷ spacing, rounded up, + 1 end stud. A 40-foot wall at 16 inches on center is 480 ÷ 16 = 30, plus 1, so 31 studs. At 24 inches on center it is 21.

3. Add the extras

  • Corners: usually 2 to 3 extra studs each, depending on how you build them.
  • Wall intersections: extra studs or blocking where interior walls tee in.
  • Each door and window: king studs, jack studs, a header, and cripples above and below.
  • Blocking for cabinets, grab bars, and fire blocking where it applies.

4. Plates and headers

  • Plates: a bottom plate and a double top plate, so three times the wall length in linear feet, plus laps.
  • Headers: one per opening, sized from the span and the load above. List each one by size and length.

5. Floors, roofs and holes

If the takeoff includes the floor or roof, count joists and rafters the same way, by span and spacing. The code answers for R802.3.1 and R502.8.1 are references to verify against your local code: one covers rafter ties where ceiling joists don't tie the rafters, the other covers notches and holes in floor joists. Check both before you order.

6. Sheathing

Wall sheathing = exterior wall length × wall height, less large openings, ÷ 32 for 4 by 8 sheets, plus waste. Add house wrap by the same area.

7. Let the tools count with you

The free stud calculator on donnie4i.com handles the common stud count at 16 or 24 inches on center. If you work from a PDF or a photo of the plan, the Measure tool in Ask Donnie (on the web and in the iPhone app) does the tracing with you: set the scale by marking a dimension you already know, then trace areas, wall lengths and counts on the sheet, and cut openings out of an area. The server works out the quantities from the points you traced and prices them from catalog unit costs, so you get an itemized takeoff to review. Check one room against a hand count before you trust a scale you set.

Write the spacing and the extras you counted per corner and opening, so the list can be checked against the plan. Confirm header sizes and structural details with your local building department.

Code sections cited

Trace the walls, get the lengths

Load a floor plan into the Measure tool, set the scale, and trace the wall runs and openings. Ask Donnie turns them into an itemized takeoff you review.

Measure a plan →

Ask Donnie is AI assistance to verify — not legal advice. Confirm the adopted edition and any local amendments with your local building department (AHJ) and a licensed professional before you build.