A shingle roofing takeoff is two counts: the sloped area, which drives shingles and underlayment, and the linear runs, which drive ridge cap, drip edge, flashing and ice barrier. Roofers who come up short usually measured the footprint and forgot that a pitched roof is bigger than the house it covers.
1. Get the footprint, overhangs included
Measure the roof plan or the building footprint, then add the eave and rake overhangs. A 30 by 50 house with 1-foot overhangs all around is a 32 by 52 roof footprint, or 1,664 square feet.
2. Apply the pitch factor
Sloped area = footprint × pitch factor, and the pitch factor is the square root of (rise² + 144), divided by 12. A 6/12 roof has a factor of about 1.118, so the 1,664-square-foot footprint becomes about 1,860 square feet of roof. Steeper roofs climb fast: a 10/12 roof is about 1.302.
3. Convert to squares and bundles
- Squares = sloped area ÷ 100. The example roof is about 18.6 squares.
- Add waste. Simple gables often carry around 10%; hips, valleys and dormers need more.
- Most three-tab and many architectural shingles run 3 bundles per square. Some heavier products run 4 or 5, so read the wrapper.
- Underlayment covers the sloped area, plus laps.
4. Take off the linear items
- Ridge and hip runs, for ridge cap.
- Eaves and rakes, for drip edge and starter strip.
- Valleys, for valley liner or metal.
- Walls and chimneys the roof meets, for step and counter flashing.
- Ice barrier from the eave edge to at least 24 inches inside the exterior wall line, where your area has a history of ice damming (R905.1.2).
5. Check the slope against the product
Asphalt shingles need a slope of at least 2:12, and slopes from 2:12 up to 4:12 need double underlayment (R905.2.2). A low-slope section changes both the underlayment line and, below 2:12, the roofing product.
6. Let the tools count with you
The free roofing takeoff calculator on donnie4i.com runs steps 2 through 4 from the footprint, pitch and linear runs. If you work from a PDF or a photo of the plan, the Measure tool in Ask Donnie (on the web and in the iPhone app) does the tracing with you: set the scale by marking a dimension you already know, then trace areas, wall lengths and counts on the sheet, and cut openings out of an area. The server works out the quantities from the points you traced and prices them from catalog unit costs, so you get an itemized takeoff to review. Check one room against a hand count before you trust a scale you set.
Write the pitch, the waste and the bundles per square next to the number. Confirm with your local building department whether ice barrier is required where you build.