← Blog

Takeoff

How to do a flooring takeoff for LVP and tile

By Ask Donnie · · 6 min read

A flooring takeoff is room areas plus waste, rounded to how the product is sold, then the edge and transition pieces. The area is simple. The waste factor and the edges are where jobs go short.

1. Measure each room

Length × width for each room, closets and halls included. Break an L-shaped room into rectangles. Keep each room as its own line, because a different product or layout in one room changes its waste.

2. Pick a waste factor by layout

  • Straight lay in a square room: many installers carry around 10%.
  • Diagonal or herringbone layouts, many small rooms, or lots of cuts: more.
  • Large-format tile and patterned plank: more, because cuts are harder to reuse.

3. Convert to what you buy

  • Plank: total area with waste ÷ square feet per carton, rounded up to whole cartons.
  • Tile: total area with waste ÷ the face area of one tile, then to boxes. A 12-inch tile covers 1 square foot; a 12 by 24 covers 2.
  • Order from one lot where you can, and keep a carton back for repairs.

4. Under the floor

  • Underlayment or pad, by area, unless the plank has one attached.
  • Subfloor repair or leveling, as an allowance or a measured line.
  • Backer board, thinset and grout for tile.
  • Moisture barrier over concrete if the product calls for it.

5. Edges and transitions

  • Baseboard or quarter round, by the room perimeter in linear feet.
  • Transition strips at every doorway where the floor changes.
  • Stair nosing, by the stair.
  • Removal and haul-off of the old floor.

6. Let the tools count with you

The free floor tile calculator on donnie4i.com goes from room dimensions to a tile count with waste, and the square footage calculator handles plank rooms. If you work from a PDF or a photo of the plan, the Measure tool in Ask Donnie (on the web and in the iPhone app) does the tracing with you: set the scale by marking a dimension you already know, then trace areas, wall lengths and counts on the sheet, and cut openings out of an area. The server works out the quantities from the points you traced and prices them from catalog unit costs, so you get an itemized takeoff to review. Check one room against a hand count before you trust a scale you set.

Write the waste factor and the carton size next to the count, so the order can be checked before it ships.

Trace the floor plan

Load a floor plan into the Measure tool, set the scale, and trace each room. Ask Donnie turns the traced areas into an itemized takeoff you review.

Measure a plan →

Ask Donnie is AI assistance to verify — not legal advice. Confirm the adopted edition and any local amendments with your local building department (AHJ) and a licensed professional before you build.