← Blog

Takeoff

Concrete takeoff: how to estimate a slab

By Ask Donnie · · 6 min read

A slab takeoff is volume math plus a short list of things that go under and around the concrete. The volume is easy to get right. The misses are usually in the base, the edges and the reinforcing.

1. Concrete volume

Cubic yards = length × width × (thickness in inches ÷ 12) ÷ 27. A 24 by 24 garage slab at 4 inches is 576 square feet × 0.333 feet ÷ 27 = about 7.1 cubic yards. Add waste for uneven subgrade and spillage. Many estimators carry 5 to 10% and round up to the next half yard the supplier will batch.

2. Thickened edges and footings

A monolithic slab has a thickened edge or footing around the perimeter, and that volume is easy to forget. Figure it separately: perimeter × footing width × extra depth ÷ 27. The code answer for R403.1 is a reference to verify against your local code. It points at a minimum footing width and thickness, and at the table for the width.

3. Base and vapor retarder

  • Gravel base: area × base depth in feet ÷ 27, then add an allowance for compaction. The free slab takeoff calculator uses 12%.
  • Vapor retarder: the slab area plus laps. The code answer for R506.2.3 is a reference to verify against your local code. It describes a polyethylene or approved retarder under slabs, with exceptions for some unheated areas.

4. Reinforcing

  • Rebar on a grid: (width ÷ spacing, rounded up, + 1) bars running the length, plus (length ÷ spacing, rounded up, + 1) bars running the width. Multiply by bar lengths and add lap length.
  • Or welded wire mesh by the sheet or roll, plus laps.
  • Chairs or dobies to hold the steel in the slab.

5. Forms, finish and the rest

  • Edge forms by the linear foot of perimeter, plus stakes.
  • Control joints, sawn or tooled, by the linear foot.
  • Finish, cure and seal by the square foot.
  • Pump or chute access, and any testing the job requires.

6. Let the tools count with you

The free slab takeoff calculator on donnie4i.com does concrete, base and rebar in one pass, and the footing calculator handles the perimeter footing. If you work from a PDF or a photo of the plan, the Measure tool in Ask Donnie (on the web and in the iPhone app) does the tracing with you: set the scale by marking a dimension you already know, then trace areas, wall lengths and counts on the sheet, and cut openings out of an area. The server works out the quantities from the points you traced and prices them from catalog unit costs, so you get an itemized takeoff to review. Check one room against a hand count before you trust a scale you set.

Write the thickness, waste and base depth beside the yardage. Confirm footing and vapor retarder requirements with your local building department.

Code sections cited

Trace the slab outline

Load a foundation plan into the Measure tool, set the scale, and trace the slab. Ask Donnie turns the traced area into an itemized takeoff you review.

Measure a plan →

Ask Donnie is AI assistance to verify — not legal advice. Confirm the adopted edition and any local amendments with your local building department (AHJ) and a licensed professional before you build.